#Hp 8710 printer software install#
#Hp 8710 printer software pro#
#Hp 8710 printer software mac#

Now, as the printer turns on, look at the Control panel of the printer to proceed with the further steps. Step 4: Utilize the PrinterвЂ™s Control Panel

Note: Always it is recommended to connect the power wire directly to the wall socket. For the first, when the printer starts, it will make some noise. After you have switched on the power supply, tap the Power button of the printer to start the device. Next, turn on the power supply to begin the installation step. This time take the power cord from the printer components and join the one end of it to the printerвЂ™s Power port and the other end to the Power supply. Step 3: Connect the Printer to the Power Outlet After that, close the input tray and continue the further steps as stated below. After that, remove the cardboard restraint by removing the blue tapes from its sides. Then, go to the front face of the printer and slide out the input tray. After removing the foam sheet from the scanner lid, close it. Also, donвЂ™t forget to remove the foam sheet by opening the scanner lid.

#Hp 8710 printer software pro#

Two pieces of tape from the input and output traysДЄll these are the pre-steps to start the HP OfficeJet Pro 8710 All-in-One printer setup process.Remove blue tape along with the cellophane, which covers the printerвЂ™s Control panel.Clear blue tapes and cellophane from the HP logo.Also, remove the tapes from these locations as stated below.

Check out the rare portion of the printer and remove the two pieces of tape from there. Thus, remove the tapes gently to avoid any damage. Step 2: Remove Every Blue Tapes from the PrinterвЂ™s BodyДЄfter taking out the printer device from the box, open the blue tapes which are attached to the different parts of the printerвЂ™s body. Lastly, take out the printer device very carefully. Setup Cartridges (952 black, cyan, yellow, and magenta ink cartridges)ДЄfter taking out all these above components, set the box on its side and make sure that the bottom of the printer face is down.Two wire Phone Cord (used to set up printerвЂ™s fax connection).

#Hp 8710 printer software mac#

Installation CD for both Windows and Mac.

The components which you will get inside the box are as follows:

After that, take out every component from it. Take a knife or any other sharp object to cut the tape from the upper portion of the box, do it carefully. This is one of the most time-consuming processes that you need to perform.

#Hp 8710 printer software install#

To install the printer in a location at first, you need to go through an unboxing step. Step 1: Unbox and Take out the Components of HP OfficeJet Pro 8710 All-in-One Printer

A secure place is a good choice, to keep your printer out from any external disturbance, while in the printing process.ДЄfter deciding the printer installation location, by keeping all these above factors in mind, proceed with the further steps to complete the HP OfficeJet Pro 8710 All-in-One printer setup process.

It is better to install the printer in such a location, which is near to both the Wi-Fi network and PC.

A Power Outlet should be nearby to the HP OfficeJet Pro 8710 printer installation location.

Some of the important things which you need to keep in your mind while choosing the printer installation location are as follows. To proceed with the HP OfficeJet 8710 setup process, first of all, you need to install it in a proper location. 1.10 Step 10: Click on OK for Online Setup Progress and Continue Steps to Perform for the HP OfficeJet Pro 8710 All-in-One Printer Setup: